Top

RV Doctor – Propane Furnace Won’t Light When Cold Outside

June 11, 2009 by Gary Bunzer · 2 Comments  
Print This Print This ·

If you're new here, you may want to subscribe to our E-mail Digest or RSS Feed. We will then send you the stories that are posted each day in an e-mail digest. We use a service called Feedburner for delivery of these emails. You will receive an e-mail from Feedburner after you subscribe and you must click on that email to activate your subscription. Thanks for visiting and enjoy all the information!

RV.Net Blog Admin

Dear RV Doc,
I have a 2001 Suburban propane furnace in my pop up camper that will not light when it is cold ( 45 degrees or less) outside. I have checked the battery and have sufficient power. The fan comes on but the ignitor never tries to ignite. When the outside temp is above 50, it will start right up. Also, once it starts once, it will re-start without fail as long as the unit is not allowed to cool. Could this be the sail switch or control board? Obviously the thermocouple works as it lights when warm. - Reed Meredith, (Mt. Crested Butte, CO)

Answer:

Reed, based on your statement “the fan comes on but the ignitor never tries to ignite”, we can probably rule out an LP delivery problem due to the colder weather. But electronics can be very problematic in colder weather though the problem is usually related to faulty or dirty connections.

Try this: unplug the connector to the control board on the furnace and carefully inspect both the plug and the board traces for corrosion or oxidation. Corroded or oxidized connections and their ability to conduct electricity can be hugely impacted by temperature and humidity changes. If there is any corrosion or oxidation on the board, temporarily clean it off using a standard pencil eraser. Be sure to blow away any eraser debris. The plug is best cleaned using a contact cleaner and protectant; I favor the products of Caig Laboratories. You can also scrape it off, but be extremely careful not to bend the connectors in the plug.

Once you have inspected and cleaned the contacts, firmly re-seat the plug onto the board and make sure it is tight. Next check all other connections to make sure they are clean and tight, including the ground connection. It is possible that your control board has an open solder joint or trace that is opening and closing with temperature changes, but this would be unusual for the temperatures you mention.

If you still have problems after performing this maintenance I would suggest the board be tested on a bench board tester. Weather could also cause the gas solenoid valve to stick, but since you have stated that the ignitor never fires chances are the gas valve is okay. It is possible the sail switch is heavy-laden with lint and needs cleaning, but typically this would result in the problem happening every time the unit tried to fire. It is, however, important to have the furnace cleaned and serviced annually which includes cleaning and testing the sail switch.

(Please feel free to comment, however, please also note that due to the volume of communications I receive from multiple channels I cannot guarantee a personal response in every instance. However, questions of an overall general interest may be considered and published in an upcoming RV Doctor column.)

[Slashdot] [Digg] [Reddit] [del.icio.us] [Facebook] [Technorati] [Google] [StumbleUpon]

Most Commented Posts

Last 5 posts by Gary Bunzer


Comments

2 Responses to “RV Doctor – Propane Furnace Won’t Light When Cold Outside”

  1. Kurt Hammerschmidt on June 11th, 2009 1:38 pm

    I once had a similar problem when my tank was inadvertantly filled with Butane instead of propane

  2. tom on June 19th, 2009 11:37 pm

    Doctor’s words always that make sense

Feel free to leave a comment...
and oh, if you want a pic to show with your comment, go get a gravatar!





Bottom